How Part E Is Marked
Part E (Q41–46) has six 3-mark numericals, two each from Solutions, Electrochemistry and Chemical Kinetics, and you answer any three. Log tables and a simple calculator are allowed.
Every numerical is marked the same way: formula 1, substitution 1, final answer with the correct unit 1. A right number without its unit loses the last mark, and a bare answer with no steps gets zero.
Write every numerical in the same lines: Given (values already in the units the formula needs), To find, Formula, Substitution and Answer with its unit. Even if the arithmetic goes wrong, the formula and substitution can still earn two marks.
Units To Check Before You Start
| Quantity | Unit the formula needs |
|---|---|
| Mass of solvent in molality | kg (or use the ×1000 form with grams) |
| Volume in | L |
| Temperature | K (add 273) |
| with R = 8.314 J K mol | J mol |
| use with C in mol L | |
| from | J mol; divide by 1000 for kJ mol |
| Rate constant | zero order: mol L s; first order: s or min |
Below are wrong answers, each with one mistake the scheme would mark down. Spot it yourself, then check the fix.
Solutions: Find and Fix
Question 1: 6.0 g of urea (molar mass 60 g mol) is dissolved in 250 g of water. Find the boiling point of the solution. ( = 0.52 K kg mol)
A student wrote: mass of solution = 256 g, so and K.
Answer. Mistake: molality uses the mass of the solvent (250 g), not the mass of the solution.
The correct answer:
Given: = 6.0 g; = 60 g mol; = 250 g = 0.250 kg; = 0.52 K kg mol
To find: Boiling point of the solution
Formula: , where
Substitution: = 0.40 mol kg, so = 0.208 K
Boiling point = 373.15 + 0.208
Answer: Boiling point of the solution = 373.36 K
Marks: formula 1, substitution 1, answer with unit 1.
Question 2: 0.50 g of a non-electrolyte dissolved in 40 g of benzene lowers its freezing point by 0.32 K. Find the molar mass of the solute. ( = 5.12 K kg mol)
A student wrote: g mol.
Answer. Mistake: the masses are in grams, so the formula needs × 1000. A molar mass of 0.2 g mol is impossible; that alone should make you look again.
The correct answer:
Given: = 0.50 g; = 40 g; = 0.32 K; = 5.12 K kg mol
To find: Molar mass of the solute,
Formula:
Substitution:
Answer: Molar mass of the solute = 200 g mol
Marks: formula 1, substitution 1, answer with unit 1.
Question 3: 0.745 g of KCl (molar mass 74.5 g mol) is dissolved in 100 g of water. Assuming complete dissociation, find the freezing point of the solution. ( = 1.86 K kg mol)
A student wrote: , K, freezing point = 272.96 K.
Answer. Mistake: KCl gives two ions (K and Cl), so the van't Hoff factor i = 2 must be used.
The correct answer:
Given: = 0.745 g; = 74.5 g mol; = 100 g = 0.100 kg; = 1.86 K kg mol; i = 2
To find: Freezing point of the solution
Formula:
Substitution: = 0.10 mol kg, so = 0.372 K
Freezing point = 273.15 − 0.372
Answer: Freezing point of the solution = 272.78 K
Marks: formula with i 1, substitution 1, answer with unit 1.
Question 4: 0.90 g of glucose (molar mass 180 g mol) is dissolved in water to make 250 mL of solution at 27 °C. Find its osmotic pressure. (R = 0.0821 L atm K mol)
A student wrote: M, atm.
Answer. Mistake: the temperature must be in kelvin: 27 °C = 300 K.
The correct answer:
Given: w = 0.90 g; M = 180 g mol; V = 250 mL = 0.250 L; T = 27 + 273 = 300 K; R = 0.0821 L atm K mol
To find: Osmotic pressure,
Formula: , where
Substitution: = 0.020 mol L, so
Answer: Osmotic pressure = 0.493 atm
Marks: formula 1, substitution 1, answer with unit 1.
Question 5: 12 g of urea (molar mass 60 g mol) is dissolved in 180 g of water at a temperature where the vapour pressure of water is 17.5 mm Hg. Find the vapour pressure of the solution.
A student wrote: , so vapour pressure of solution = mm Hg.
Answer. Mistake: is the lowering of vapour pressure, not the vapour pressure of the solution. A little urea can't make the vapour pressure fifty times lower than water's.
The correct answer:
Given: = 12 g; = 60 g mol; = 180 g; = 18 g mol; = 17.5 mm Hg
To find: Vapour pressure of the solution, p
Formula:
Substitution: = 0.0196
Lowering of vapour pressure = 17.5 × 0.0196 = 0.343 mm Hg, so p = 17.5 − 0.343
Answer: Vapour pressure of the solution = 17.16 mm Hg
Marks: formula 1, substitution 1, answer with unit 1.
Electrochemistry: Find and Fix
Question 6: Find the emf at 298 K of Zn | Zn (0.01 M) || Ni (0.1 M) | Ni. ( = −0.76 V, = −0.25 V)
A student wrote: = 0.51 V; V.
Answer. Mistake: the fraction is upside down. For Zn + Ni → Zn + Ni, the product ion Zn goes on top.
The correct answer:
Given: [Zn] = 0.01 M; [Ni] = 0.1 M; = −0.76 V; = −0.25 V; n = 2
To find:
Formulae: and
Substitution: = 0.51 V
Answer: emf of the cell = 0.54 V
Marks: formula 1, substitution 1, answer with unit 1.
Question 7: Find the emf at 298 K for , if = 1.56 V.
A student wrote: V.
Answer. Mistake: the coefficient 2 in front of Ag becomes a power, so [Ag] must be squared.
The correct answer:
Given: = 1.56 V; [Zn] = 0.1 M; [Ag] = 0.01 M; n = 2
To find:
Formula:
Substitution: and , so
Answer: emf of the cell = 1.47 V
Marks: formula 1, substitution 1, answer with unit 1.
Question 8: The conductivity of 0.05 M KCl solution is 6.67 × 10 S cm. Find its molar conductivity.
A student wrote: S cm mol.
Answer. Mistake: C is in mol L but is per cm, so the × 1000 (1 L = 1000 cm) is missing.
The correct answer:
Given: = 6.67 × 10 S cm; C = 0.05 mol L
To find: Molar conductivity,
Formula:
Substitution:
Answer: Molar conductivity = 133.4 S cm mol
Marks: formula 1, substitution 1, answer with unit 1.
Question 9: Find for CaCl. ( of Ca = 119.0 and of Cl = 76.3 S cm mol)
A student wrote: S cm mol.
Answer. Mistake: one CaCl gives two Cl ions.
The correct answer:
Given: (Ca) = 119.0 S cm mol; (Cl) = 76.3 S cm mol
To find: (CaCl)
Formula (Kohlrausch's law):
Substitution:
Answer: (CaCl) = 271.6 S cm mol
Marks: formula 1, substitution 1, answer with unit 1.
Question 10: A current of 3.0 A is passed through ZnSO solution for 1930 s. Find the mass of zinc deposited. (Zn = 65.4 g mol, F = 96500 C mol)
A student wrote: Q = 5790 C = 0.06 F, so mass = 0.06 × 65.4 = 3.92 g.
Answer. Mistake: Zn + 2e → Zn needs 2 F per mole, so 0.06 F deposits only 0.03 mol.
The correct answer:
Given: I = 3.0 A; t = 1930 s; M = 65.4 g mol; n = 2; F = 96500 C mol
To find: Mass of zinc deposited, w
Formula:
Substitution:
Answer: Mass of zinc deposited = 1.96 g
Marks: formula 1, substitution 1, answer with unit 1.
Question 11: For the Zn–Ni cell in Question 6, = 0.51 V. Find .
A student wrote: kJ mol.
Answer. Mistake: the number is right, but F in C mol and E in V give J mol. Writing kJ makes the answer a thousand times too big and costs the unit mark.
The correct answer:
Given: n = 2; F = 96500 C mol; = 0.51 V
To find:
Formula:
Substitution:
Answer: = −98430 J mol (−98.43 kJ mol)
Marks: formula 1, substitution 1, answer with unit 1.
Chemical Kinetics: Find and Fix
Question 12: A first order reaction has k = 2.303 × 10 min. How long will it take for 60% of the reaction to be complete? (log 2.5 = 0.3979)
A student wrote: min.
Answer. Mistake: if 60% has reacted, 40% is left, so [R] = 40, not 60.
The correct answer:
Given: k = 2.303 × 10 min; taking = 100, after 60% reaction = 40
To find: Time, t
Formula:
Substitution:
Answer: Time for 60% completion = 39.8 min
Marks: formula 1, substitution 1, answer with unit 1.
Question 13: For a reaction, = 53.6 kJ mol and k = 2.0 × 10 s at 300 K. Find k at 310 K. (R = 8.314 J K mol, log 2 = 0.3010)
A student wrote: , so is about s, the same as before.
Answer. Mistake: was left in kJ while R is in J. Convert: 53.6 kJ mol = 53600 J mol. A 10 K rise that leaves the rate unchanged should make you suspicious.
The correct answer:
Given: = 53.6 kJ mol = 53600 J mol; = 2.0 × 10 s; = 300 K; = 310 K; R = 8.314 J K mol
To find: Rate constant at 310 K,
Formula:
Substitution: = 0.3010, so = 2 and = 2 × 2.0 × 10
Answer: Rate constant at 310 K = 4.0 × 10 s
Marks: formula 1, substitution 1, answer with unit 1.
Question 14: For a reaction with = 0.50 mol L, the rate constant is 2.5 × 10 mol L s. Find the half-life.
A student wrote: s.
Answer. Mistake: the unit of k, mol L s, shows a zero order reaction. 0.693/k is only for first order.
The correct answer:
Given: = 0.50 mol L; k = 2.5 × 10 mol L s (zero order)
To find: Half-life,
Formula (zero order):
Substitution:
Answer: Half-life = 100 s
Marks: formula 1, substitution 1, answer with unit 1.
Question 15: In a first order reaction, the concentration of the reactant falls from 0.50 M to 0.05 M in 23.03 minutes. Find the rate constant.
A student wrote:
Answer. Mistake: the working is right, but the answer has no unit, so the third mark is lost.
The correct answer:
Given: = 0.50 M; = 0.05 M; t = 23.03 min
To find: Rate constant, k
Formula:
Substitution:
Answer: Rate constant, k = 0.1 min
Marks: formula 1, substitution 1, answer with unit 1.